Thursday, 03 September 2020
  4 Replies
  1.8K Visits
  Subscribe
I had Keymouse ChairTrack on sofa armrest (platform and velcro do not fit) and dropped it a few times over a year.
Yeah it's my fault for dropping, but didn't expect 4/5 screws to be undone.
The upper and lower plastic cases dislocated.
Now I have tightly secured with sticky tape.

Suggest larger screws, wider screws with larger threads for the two cases.
1 year ago
·
#2200
Upper case plastic receiving hole threads are destroyed, so screws cannot work.
1 year ago
·
#2201
Sorry about the issue. We will consider different screws or a different thread type.
1 year ago
·
#2202
I'd go with metal nut for the threads, while the plastic is just holding it in, that way there's a larger chunk of plastic holding the nut, less likely to break, and if the nut goes bad, you can always replace it. Have the hole be hexagonal, but in a way you can slide a nut in and out tightly.
1 year ago
·
#2204
Kresimir, I like this idea. We could maybe just make them tight press fit. We'll explore this.
  • Page :
  • 1
There are no replies made for this post yet.
Be one of the first to reply to this post!
Submit Your Response
Upload files or images for this discussion by clicking on the upload button below.
Supported: gif,jpg,png,jpeg,zip,rar,pdf
· Insert · Remove
  Upload Files (Maximum 2MB)
Captcha
To protect the site from bots and unauthorized scripts, we require that you enter the captcha codes below before posting your question.